Prev: 1DEC Up: Map Next: 1E39
1E27: THE 'DATA' COMMAND ROUTINE
The address of this routine is found in the parameter table.
During syntax checking a DATA statement is checked to ensure that it contains a series of valid expressions, separated by commas. But in 'run-time' the statement is passed by.
DATA 1E27 CALL SYNTAX_Z Jump forward unless checking syntax.
1E2A JR NZ,DATA_2
A loop is now entered to deal with each expression in the DATA statement.
DATA_1 1E2C CALL SCANNING Scan the next expression.
1E2F CP "," Check for a comma separator.
1E31 CALL NZ,CHECK_END Move on to the next statement if not matched.
1E34 RST $20 Whilst there are still expressions to be checked go around the loop.
1E35 JR DATA_1
The DATA statement has to be passed by in 'run-time'.
DATA_2 1E37 LD A,$E4 It is a 'DATA' statement that is to be passed by.
This routine continues into PASS_BY.
Prev: 1DEC Up: Map Next: 1E39